WIRING HARNESSES

Knock Sensor wire end- single

Single wire knock sensor plug - often used on 5.7 engines. Must splice to install, recommend using heat shrink on your splice. 

Wire harness engine side- 3 wire sensor

3 wire sensor harness for R020038 and other applications using a 3 wire plug

Fuses

Fuses used on most engines - select from type. See picture. 

Three wire GM plug/harness

ACDelco Gold Three wire plug, Multi-Purpose Wire Connector with Leads Often used on sensors on the GM engines. Saves from having to replace whole harness.  

PIGTAIL, 12" MALE TO FEMALE

One foot harness extension, 8 prong rectangular male to 8 prong rectangular female. Can be cut in half and spliced to make a new connection for the engine to boat harness. Bin Number (ISBN): 92713  

COVER ELECTRICAL PANEL

ELECTRIC BRACKET COVER R126007A PCM FORD CARBURETED ENGINES, THIS PLASTIC COVER GOES OVER THE STARTER RELAY, CIRCUIT BREAKER ETC. CURRENT COVER IS BLANK WITH NO EMBOSSED PCM LOGO'S.   Bin Number (ISBN): 112411  

WIRE HARNESS, FORD CARB

FORD ELECTRONIC IGNITION WIRE HARNESS R121025A PCM Carb FORD 87 ON (No Resistor Wires)Can be used on 87 and prior with ballast resistor but you will need to finish the conection to the coil. This harness is not designed for use with an alternator...

WIRE HARNESS 10' EXTENSION

WIRE HARNESS, 10' EXTENSION Engine to dash 8 prong rectangular plug 10 foot wiring harness extension. PCM Fords from 70's on all Indmar Ford's and GM thru 90's. Most boats will have to cut off prong at the dash end and hard wire it. Bin Number...

RELAY HARNESS FOR R130011A AND R130011 RELAYS

Used to replace worn or damaged relay socket for R130011A and R130011 relays