Rudder

Rudder Moomba/Supra Direct Drive

Fits most direct drive supra like Comp, Conbrio, Sunsport,- and some Moomba direct dirves. This is the facory replacement rudder assembly from Skiers Choice.

Rudder Assembly Moomba/Supra V-Drive

Rudder & Port (assembly) used on Moomba/Supra V-drive applications.

Rudder Assembly - Marine Hardware

Marine Hardware rudders are cast and machined in the USA. Tiller arm is double keyed for left or right position, this rudder has a 4" X 4" square port.  Universal Replacement Rudder assembly for tournament ski boats. (Most V-drievs...

Rudder Assembly Drop Arm Tiller

For V-drives with drop-down tiller arm (drops down 1"). 4" X 4" rudder port flange (slotted bolt holes) and 2" O.D. port. This rudder will have RTPL cast on it and is 14" long. There is a RTPN casting that is only 12.50" long. This can replace it if...

Rudder Assembly, N J Port Malibu

Fits Malibu around 1988 thru 1994, Marine Hardware rudder assembly with 3-1/4" x 4" rectangular rudder port (2" bore). 7" long tiller arm is keyed for port or starboard side installation. Old Item # 92012

Marine Hardware 1" Rudder Box Seal Kit

"MARINE HARDWARE" RUDDER RENEW KIT Fits 1998 UP Marine Hardware Rudders Only. Marine Hardware rudders will usually be stamped MH as the first 2 digits of the part number on the rudder. Will not fit older style Marine Hardware rudders that have a nylon...

ZINC, RUDDER 3-3/4

A sacrificial magnet to fight electrolysis in salt water and brackish water applications. 3-3/4" O.D. zink with stainless bolt/nut and copper bushing for permanent ground. Bin Number (ISBN): 101812  

SEAL KIT, #1010-1 RUDDER PORT

SEAL KIT, #1010-1 RUDDER PORT Fits SEF (South Eastern Foundries) 1010-1 rudder port. Includes 2 lip seals, 2 O-rings, 1 snap ring, 1 plastic bushing, 2 set screws and 1 zerk. Seal has #11060 on it and measures 1-1/2" O.D. and 1-1/8 I.D.   Bin Number...

3M 5200 SEALANT FAST CURE, WHITE 3 OZ

For thru-hull fittings above and below the water line 3 oz tube. Watertight bonding sealing of fiberglass and wood. Ideal for thru-hull and deck fittings and deck to hull joints. Flexible fully cures in 20-24 hours. Use for...

SHAFT SEAL ONLY OJ 1-1/8 W/ SNAP RING

Replacement seal for GLIDE GMSS and OJ dripless systems with 1-1/8" shafts. Also fits OJ rudder ports original equipment on Mastercrafts 2003 thru 2012 (same parts as OJ2041B). Does not fit the GMSS shaft seals that have 6 screws on the end cap.