EFI SENSORS

INDMAR DIGITAL OIL PRESSURE SENDER 55-1379

Indmar Digital Oil Pressure Sender. Indmar did not use until 2007 or so. The oil pressure sender is an important component of the engine, as it helps to ensure that the oil pressure is maintained at the correct level. If the oil pressure...

WATER TEMP SENDER R020019

Sending Unit for the ECM, most GM 2 wire snap in connector, 3/8 NPT. Indmar Pt# 556013, later model LT1 screws into the T-stat housing (instead of 1 wire sender). Bin Number (ISBN): 2004202

PRE CATALYST 02 SENSOR 6.2L RAPTOR

Pre Catalyst 02 Sensor for 6.2L Raptor marine engine. Bin Number (ISBN): 10822  

O2 SENSOR, INDMAR ETXCAT 4 WIRE

Indmar ETXCAT exhaust pre & post catalyst manifolds. Used post cat only on Ford Raptor 6.2L engines, replaces 556162B.

PCM O2 OXYGEN SENSOR CES 4 WIRE R020051

OXYGEN SENSOR PCM ALL, PRE AND POST CAT.   Bin Number (ISBN): 62612    

SENSOR, MANIFOLD AIR TEMP

Intake Manifold Air Temp Sensor 6.0L

SENSOR HVS CAM POSITION

GM 5.7 CAM POSITION SENSOR FITS INSIDE HVS DISTRIBUTOR

THROTTLE POSITION SENSOR (TPS)

Throttle Body Injection (TBI) GM all 94 and up. All LT1 Corvette and some early Monsoon. Indmar Pt# 55-6032. Bin Number (ISBN): 2004193

KIT KNOCK SENSOR BRASS FITTING W/BOLT

FLAT RESPONSE KNOCK SENSOR KIT, INCLUDES BRAAS BLOCK FITTING AND BOLT FOR SENSOR. FITS ALL 5.7 KNOCK SENSORS AND REPLACES THE OLD STUD STYLE POST.

SENSOR, TPS (GM/MPI)

Replaces Crusader 49061 Replaces Indmar 55-6103 Replaces Marine Power 462856 Replaces Quicksilver 8M0097035 Replaces Volvo 3857487 Replaces Holley 9920-104

SENSOR, MAP, 5.7 MPI

GM MEFI MAP SENSOR PORT FUEL INJECTION. Indmar Pt# S556102. Pt# on sensor 09359409. Will not fit PCM 8.1L or 6.0L use Pt# R020036, it does fit Indmar 8.1L

IDLE AIR CONTROL, MPI

Some Multi Port EFI, PCM Apex, Indmar LTR (Not for 2002 up PCM 5.7). Manufacturer's Part Number 208711370G on the wiring connector.This one goes in the monovalve. NOT for Indmar Monsoon I (blue anodized throttle body) use R084002. Will fit...

POTENTIOMETER, ASSY

POTENTIOMETER for 2006 model GM boats that are Drive By Wire NOTE: if your wire harness comes from the 'other' side you can just can take the screws out of the one side, pull that part off rotate and reinstall to make installation work.